31
EN
STRADA DBE . | MANUEL | .. | V.
3. OPERATION
The user selects the desired speed to reach the room temperature by using the ‘-’ and ‘+’ buttons.
Heat more slowly
Less dynamic
More static
Heat faster
More dynamic
Less static
The device acts based on the measured temperature. Using the ‘+’ and ‘-’ buttons on the
LED control panel, you can gradually change the speed and duration of the activators.
The unit starts as soon as the control panel is in heating mode, the requested room temperature
has not been reached and the water temperature is > C.
All functions are disabled until the user switches on the unit via the control panel.
O
O
Boost function: The unit runs at maximum speed for minutes. The LED’s are flashing slowly.
MODEMODE
MODE
3 sec
Deactivating
Briefly press the [+] button . The device returns to the selected mode. .
The boost mode will stop automatically if the water temperature drops below °C during the
boost mode.
To Next Page
Loading...
