Jaga STRADA DBE 2.0 User Manual

32
STRADA DBE . | MANUEL | .. | V.
Red LEDs are flashing: the water temperature for heating is too low
MODEMODE
MODEMODE
Error sensor - Check the water temperature sensor
Error sensor - Check the room temperature sensor
Control panel error codes
LED flashes rapidly in the color of the set mode .
MODE
15 sec
. Short press the [-] or [+] button to adjust the set temperature .
Factory settings
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
24 C
30 C
36 C
26 C
32 C
38 C
28 C
34 C
4. SETTINGS VIA CONTROL PANEL
4.1. ADJUSTING THE WATER TEMPERATURE
4.1.1. Adjusting the minimum water temperature for heating
By increasing the water temperature setting, the unit will start later. If the water temperature is set
lower, the unit will start sooner .
In combination with a heat pump, it may be necessary to reduce the water temperature .
. Put the device in heating mode
. Hold down the [Mode] and [+] simultaneously until the last  LEDs start flashing .
. The device returns to the selected mode. (±sec).
5. NOTIFICATIONS

Jaga STRADA DBE 2.0 Specifications

General

Brand	Jaga
Model	STRADA DBE 2.0
Category	Heater
Language	English