33
DE FR EN ESEN
Fig. 2
2. Installation of the gate operator
• The base unit of the gate operator requires a concrete pad in order to maintain proper
stability. The concrete pad should be of the dimensions (approximately) 450 mm x 300 mm
x 200 mm (LxWxH) in order to provide adequate weight and structure to ensure a sturdy
construction.
• Put the hooks into the concrete pad (for the distances between the hooks, see Fig. 3) before
it is cured.
• After the concrete has cured, mount the gate operator base to the concrete pad.
• Make sure that the base is properly leveled.
• Check the operator and make sure it is parallel to the gate.
• Alternatively, you can use wedge anchors to x the operator.
Fig. 3
Gate operator
Gear
Groundsill
Input
power
204 mm
90 mm
Hook
Nut
To Next Page
Loading...