JAM Pedals Delay Llama

To Next Page

Delay Llama

The Delay Llama is a tone machine

that will become an indispensable

part of your sound adding warmth

and depth through organic repeats

which seamlessly integrate into

your playing, courtesy of its BBD

chips, faithful reproductions of the

Panasonic MN3205.

Its straight-forward layout is

addressed to delay users who are

looking to elegantly enhance their

hard-earned tone, similarly to how

a tape-echo machine would with no

frills.

The mk.3 version expands on the

utility value of this modern classic,

while retaining the form factor and

ease of use, by introducing Tap

Tempo with subdivisions and Hold

(self oscillation) functions.

The Delay Llama comes with 600ms

max. delay time, and can also be

used with bass guitars!

CONTROLS

y T: Delay Time

y R: Amount of Repeats

y L: Delay Level on top of dry signal

y TOGGLE-SWITCH: Tap Tempo

Subdivisions (top to bottom: 8th,

quarters, dotted 8th)

y Internal trimmer (blue rectangle)

to set the max. number of repeats

y Internal trimmer to set the trails'

fade out time (only applicable

when the pedal is set in buffered

bypass mode, read below)

FOOTSWITCHES

y LEFT: Turns the pedal ON / OFF

y TAP:

• MOMENTARY minimum 2

consecutive stomps: Tap Tempo

• LATCHING engages HOLD

(oscillation) for as long as it is

pressed

If you slap this

Llama, it will slap

back!

Need help?

Do you have a question about the JAM Pedals Delay Llama and is the answer not in the manual?

Summary

Delay Llama Introduction and Features

Controls

Delay Time (T)

Sets the delay time for the repeats.

Amount of Repeats (R)

Adjusts the feedback or regeneration of the delay.

Delay Level (L)

Controls the volume of the delayed signal relative to the dry signal.

Tap Tempo Subdivisions

Selects rhythmic subdivisions for tap tempo input (e.g., 8th, quarter, dotted 8th).

Internal Trimmer for Max Repeats

Adjusts the maximum number of delay repeats.

Internal Trimmer for Trails Fade Out

Sets the fade-out time for trails in buffered bypass mode.

Footswitches

ON;OFF Footswitch

Turns the pedal ON or OFF.

Tap Tempo; HOLD Footswitch

Sets tap tempo via consecutive stomps or engages HOLD (self-oscillation) when pressed.

Bypass Mode Selection

Changing to Buffered Bypass

Procedure to switch from true bypass to buffered bypass mode for natural trail fade-out.

Changing to True Bypass

Procedure to switch back to true bypass mode, indicated by LED blinking twice.

Internal Trimmer Locations

Trimmer 1: Trails Fade Out Time

Location for the internal trimmer that adjusts the trails' fade out time.

Trimmer 2: Max Repeats

Location for the internal multi-turn trimmer to set the maximum number of repeats.

Specifications

Bypass Type

Supports both True and Buffered (Trails) Bypass modes.

Power Requirements

Requires a 9V DC adaptor (tip-negative) and consumes 120 mA.

Physical Dimensions

Compact dimensions: 7.5 x 12 x 5.6 cm (2.9 x 4.7 x 2.2 inches).

Weight

Lightweight at 280g (0.6 lbs).