2-5
Chapter 2 — Installation
• After using your RAC, you should turn off the RAC while your vehicle is
not being used. Power consumption of the RAC display, although minimal,
may drain your battery if the vehicle is idle for an extended time with the
RAC connected and turned on. This is particularly true if your battery is
in poor condition.
• The AutoLink II is turned on and off by the RAC’s power switch and
as such can be left connected to the OBD port while not in use. Note that
this was not the case with the original AutoLink I. The AutoLink I should
always be disconnected from the OBD when not in use.
To Next Page
Loading...