What to do if JAMO Receiver DMR 60 remote control not working?
If your JAMO Receiver DMR 60 unit isn't responding to the remote control, first ensure that new batteries (2 x “AAA” R6P) are properly inserted. If batteries are new, make sure they aren't worn out and replace them. Also, verify that you are pointing the remote directly at the remote sensor on the DMR 60, and that you are within 5 meters of the unit.
Why is there no sound coming from my JAMO Receiver?
If your JAMO Receiver has no sound, the volume might be set to 0. Try turning up the volume. Also, check the speaker cords to ensure they are correctly connected.
How to fix no picture on my JAMO Receiver?
If your JAMO Receiver shows no picture, ensure that the TV is switched ON and connected correctly.
What to do if my JAMO DMR 60 is not turning on?
If the power is not supplied to your JAMO Receiver even though the power cable is connected, make sure the power plug is securely connected to the outlet. Also, verify that the wall plug is turned ON.
Why can't JAMO Receiver play the disc?
If your JAMO Receiver can’t play a disc, check if the disc label is facing up. If it is, the disc might be empty, or its format may not be supported by the DMR 60. Try another disc. The disc might also be dirty or defective, so clean it or dispose of it if necessary. Finally, ensure the disc is properly placed within the disc tray guide.
What to do if JAMO Receiver DMR 60 does not respond to some operating commands?
If your JAMO Receiver DMR 60 does not respond to some operating commands during playback, operations may not be permitted by the disc. Read the instructions on the disc.
Configure the video output format (NTSC or PAL) for the receiver.
Select the output type for video signals (SCART, S-Video, Component, Progressive).
Set the aspect ratio (4:3 LB, 4:3 PS, 16:9) for the display.
Set the display language for the OSD menu.
Select the desired audio language for playback.
Choose the preferred subtitle language for movies.
Select the language for the system's menu interface.
Adjust delay time for the center channel speaker.
Adjust delay time for surround sound channels.
Reduce dynamic range for quieter playback.
Test all speakers to ensure correct connection and function.
To Next Page
General
