upturned. Make sure wrist is in correct position, to avoid body movement. Sit still and do not
talk or move during the measurement.
After the cuff has been appropriately positioned on the wrist and connected to the blood
pressure monitor, the measurement can begin:
a) Press the Stop/Start button. The pump begins to inflate the cuff. In the display, the
increasing cuff pressure is continually displayed.
b) After automatically reaching an individual pressure, the pump stops and the pressure slowly
falls. The cuff pressure is displayed during the measurement.
c) When the device has detected your pulse, the heart symbol in the display begins to blink.
d) When the measurement has been concluded, the measured systolic and diastolic blood
pressure values, as well as the pulse will be displayed.
e) The measurement results are displayed until you switch the device off. If no button is
pressed for 60seconds, the device switches off automatically.
Recommended Use Methods
1. Recommendation that the PATIENT relax as much as possible and not talk during the
measurement PROCEDURE
2. Recommendation that 5 min should elapse before the first reading is taken
3. Any reading can be affected by the measurement site, the position of the PATIENT,
exercise, or the PATIENT’S physiologic condition
4. Performance of the AUTOMATED SPHYGMOMANOMETER can be affected by extremes
of temperature, humidity and altitude
5. To stop the inflation or measurement, push the START/STOP button,the monitor will stop
inflating, start deflating, and will turn off
6. After the monitor has detected your blood pressure and pulse rate, the cuff automatically
deflates. Your blood pressure and pulse rate are displayed.
7. If getting a suspicious reading after finishing measurement,you should consult the doctor.
Self-diagnosis of measurement results are dangerous.
8. The monitor will automatically turn off after one minute.
Picture-05
To Next Page
Loading...
