12
Store a speed dial number
E.g. Store a speed dial number “911” on button 5, 1 is the program parameter to store a speed dial number, the whole string is: *#1235#15911#
Note: You can store speed dial numbers to 0~9 buttons, and just need change the button number after the program parameter. The speed
dial number can be 3~14 digits. M1 on the keyboard for speed dial number1, M2 on the keyboard for speed dial number2, M3 on the keyboard
for speed dial number3.
Delete a speed dial number
E.g. Delete the speed dial number on button 5, 1 also is the program parameter to delete a speed dial number, the only difference is no phone number
followed the button number, the whole string is: *#1235#15#
Hold time for speed dial
E.g. Change holding time to 5s to launch the speed dial number, 41 is the program parameter to change the holding time, the whole string is: *#1235#415#
Note: The holding time can be 1~9 seconds, default is 3 seconds.
E.g. If you stored a speed dial number 911 on button 5, you can lift the handset and press button 5 and hold for 3 seconds, then release the
button, while 911 is dialed out.
Store auto dial number (CB version only)
E.g. Store a auto dial number “911”, 11 is the program parameter to store a auto dial number, the whole string is: *#1235#11911#
Note: The software for CB version is different from full keypad version.
Delete auto dial number (CB version only)
E.g. Delete the auto dial number on button 5, 11 also is the program parameter to delete auto dial number, the only difference is no phone number
followed the button number, the whole string is:*#1235#11#
Talk time limit
E.g. To limit the talk time to 5 minutes, 20 is the program parameter to set the talk time, the whole string is: *#1235#205#
Note: The talk time can be set to 0~255 minutes, default value is 0 and 0=no limit.
Change flash time
E.g. Change the flash time to 100ms, 31 is the program parameter to change the flash time, the whole string is: *#1235#312#
Note: The flash time has 1~9 levels, 1=50ms, 2=100ms, 3=150ms, 4=200ms, 5=250ms, 6=300ms, 7=350ms, 8=400ms, 9=450ms.
Default value is 5.
Auto answer
61 is the program parameter to switch auto answer, E.g. To enable auto answer after 3 ringing,the whole string is: *#1235#613#
Note: 0=disable, 1=auto answer after 1 ringing, 2=auto answer after 2 ringings, 3=auto answer after 3 ringings, 4=auto answer after 4 ringings,
5=auto answer after 5 ringings, 6=auto answer after 6 ringings, 7=auto answer after 7 ringings, 8=auto answer after 8 ringings, 9=auto answer
after 9 ringings.
Default value is 0.
This function is for connecting external horn speaker.
Voice control
Push the Voice control button to control Voice
Switch between speakerphone and handset mode
Press the speakerphone button to switch between handset and speakerphone mode
Mute mic
Press the M button to mute mic when on the line
To Next Page
Loading...
Need help?
General