Need help?Do you have a question about the Jands HP6 and is the answer not in the manual?
General| Number of Channels | 6 |
|---|---|
| Maximum Output Current per Channel | 10 A |
| Frequency | 50/60 Hz |
| Cooling | Fan Cooled |
| Control Protocol | DMX512 |
Details the three-phase and single-phase mains power supply wiring configurations.
Describes dimmer behavior and operator control when a power phase fails.
Explains the function and characteristics of output circuit breakers.
Discusses inrush current from cold lamps and its effect on circuit breakers.
Details how SCRs and triacs are protected from short circuits.
Provides recommendations for running dimmers at outdoor shows with local power.
Details the layout and function of front panel controls and indicators.
Explains power supply configurations, wiring, and filtering for the dimmers.
Describes the thyristor firing control method used in the dimmers.
Details the SCR components and their triggering mechanisms for dimming.
Explains the function of output chokes and filtering in reducing EMI.
Describes the function and behavior of Load and Drive LEDs.
Details the microprocessor, memory, and I/O components of the CPU card.
Covers the switches, LEDs, and encoder circuitry on the front panel.
Outlines the navigation and operation of the dimmer's menu system.
Details the various modes like VOLT, TEMP, LAW, PREH, P.FLT, TERM, CHEK, V.COM, LOCK.
Explains how to set DMX start channels and banks for dimmer addressing.
Describes how to record DMX Snapshots and user-defined Scenes.
Explains how to run Snapshots, Scenes, and pre-recorded chases.
Details how to test individual channels or groups of channels.
Provides instructions for performing a deep clear of dimmer settings.
Explains how to take individual channels off-line.
Covers the procedure and precautions for updating dimmer software.
Details output, thermal, and overvoltage protection features.
Describes issues like short-circuits and faulty triacs/SCRs.
Addresses display messages indicating errors and system issues.
Explains how DMX signal loss affects dimmer operation.
Describes how phase presence is indicated and warnings for faults.
Discusses inrush current issues with cold lamps and preheat solution.
Covers issues related to the CPU card's lithium battery and memory.
Provides a table for diagnosing common symptoms and their causes/remedies.
Step-by-step guide for removing the CPU card from the dimmer.
Instructions for safely removing the front panel circuit card.
Details the process for replacing triacs or SCRs on the dimmer.
Procedure for removing the main dimmer "engine block" assembly.
Explains how to run built-in CPU diagnostic tests.
Provides a functional test procedure for the dimmer's output card.
Describes DIP switch settings for phase compensation adjustments.
Details the procedure for recalibrating the dimmer's output voltage.
Lists pin assignments for Socapex and Wieland output connectors.
Specifies the pin configuration for DMX input and loop connectors.
Details channel assignments for different DMX banks.
Provides standard colour coding for mains wiring connections.
Pinout details for CPU card power, front panel, and DMX connectors.
Pinout details for front panel card CPU and other connectors.
Pinout details for output card CPU and temp sense connectors.
To Next Page