Need help?Do you have a question about the Jands HP12 and is the answer not in the manual?
Describes the layout and components of the dimmer's front panel.
Details on connecting mains power for rack-mount and wall-mount units.
Describes different output connector options for rack and wall mount dimmers.
Explains how to connect the DMX-512 control signal to the dimmer.
Outlines the correct sequence for powering up the dimmer and control desk.
Explains the tree-like menu structure and navigation using controls.
Procedure to reset the dimmer to factory defaults in case of software lockup.
How to take a channel off-line or bring it back on-line.
Procedure for updating the dimmer's operating software.
Overview of the dimmer's protection features.
Describes faults related to output circuits and the LOAD LED function.
How to handle specific error messages displayed by the dimmer.
Explains behavior during DMX signal loss and the DMX IN LED.
Explains the function of the PHASE LEDs and warnings for phase loss.
A table listing common symptoms, causes, and remedies for faults.
Guidelines for mounting dimmers in standard 19-inch racks.
Instructions for mounting in 465mm deep racks using standard ears.
Instructions for mounting in deeper racks using extender brackets.
Specifies ventilation requirements for rack-mounted dimmers.
Overview of wall mounting options for specific dimmer models.
How to mount wall-mount dimmers into equipment racks.
Instructions for flush mounting dimmers to a wall.
Mounting dimmers to straddle cable trays.
Describes creating an enclosure for conduited cable entry.
How to hang dimmers from bar hooks in lighting trusses.
Describes installing flying lead output patching options.
Step-by-step guide for attaching the dimmer unit to its bracket.
Specifies ventilation requirements for wall-mounted dimmers.
Instructions for cleaning the dimmer's front panel safely.
Procedures for cleaning internal components, fans, and air paths.
Recommended maintenance schedule and checks for installed and touring units.
Pin assignments for 19-pin Socapex output connectors.
Pin assignments for DMX input and loop connectors.
Table mapping DMX bank numbers to channel ranges.
Details internal mains wiring configurations and options.
Details on connecting to a standard three-phase power supply.
How to configure and connect the dimmer for single-phase power.
Instructions for connecting to a 220V delta three-phase supply.
Notes on mains wiring and protection system considerations in Europe.
To Next Page
General