Contents i
Revision 2 - 20 March, 1997 HP SERIES DIMMER OPERATING MANUAL
EMC COMPLIANCE
This product is approved for use in Europe and Australia/New Zealand and conforms to the following standards:
European Norms Australian / New Zealand
Standards
EN 50081-1 AS/NZS 4252.1
EN 50082-1 AS/NZS 4251.1
EN 60950 AS/NZS 3260
To ensure continued compliance with EMC Directive 89/336 and the Australian Radiocommunications Act 1992, use
only high quality data cables with continuous shield, and connectors with conductive backshells. Examples of such
cables are:
DMX: Belden 8102 100% Aluminium foil screen, 65% Copper braid.
JANDS ELECTRONICS PTY LTD 1997
All rights reserved
DISCLAIMER
Information contained in this manual is subject to change without notice and does
not represent a commitment on the part of the vendor. JANDS ELECTRONICS P/L
shall not be liable for any loss or damage whatsoever arising from the use of
information or any error contained in this manual.
It is recommended that all service and repairs on this product be carried out by
JANDS ELECTRONICS P/L or its authorised service agents.
JANDS HP Series dimmers must only be used for the purpose they were intended by
the manufacturer and in conjunction with this operating manual.
JANDS ELECTRONICS P/L cannot accept any liability whatsoever for any loss or
damage caused by service, maintenance or repair by unauthorised personnel, or by
use other than that intended by the manufacturer.
Manufactured in Australia by:
JANDS ELECTRONICS PTY LTD ACN 001 187 837
40 KENT RD
Locked Bag 15
MASCOT NSW 2020
AUSTRALIA
PHONE: +61-2-9582-0909
FAX: +61-2-9582-0999
EMAIL: jandsinfo@jands.com.au
To Next Page
Loading...
Need help?
General
