Jands HP6 - Page 36

MODE 2: TERMINATION, CHECK, VOLTAGE COMPENSATION & LOCK
[10]
DISPLAY = "CH1*DMX-1*Level- 19*Volt-240*Law-Linear power* Preheat-Off*Preheat value- E*Status-Enabled"
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
Voltage compensation applied Voltage compensation not applied
DMX Termination
Term "On" Term "Off"
DMX terminated DMX not terminated
From
"P.FLT"
[10]
ENTER
ENTER
ENTER
ENTER
Dimmer Parameter Readout Mains Voltage Compensation
ENTER
ENTER
Dimmer locked
ENTER
ENTER
Dimmer unlocked
Turn left for 1 step
Turn right for 1 step
Turn right for 1 step
Dimmer user lock
NORMAL
Adjust to scroll
through channel
Figure 4.1 B