Jandy DEL Series Filters - Table of Contents

Equipment Information RecordEquipment Information Record
Date of Installation
Initial Pressure Gauge Reading (with clean filter)
Pump Model Horsepower
Filter Model Serial Number
Notes:
Table of Contents
1
SECTION 1
Safety Information
1.1 Important Safety Warning....................... 2
1.2 General Safety Instructions.......................2
SECTION 2
General Information
2.1 Introduction............................................. 3
2.2 Description.............................................. 3
2.3 General Requirements.............................3
2.4 DE Requirements.................................... 3
2.5 Specifications and Dimensions................3
SECTION 3
Installation Instructions
3.1 Filter Location......................................... 4
3.2 Filter Preparation.................................... 4
3.3 Filter Installation...................................... 4
3.4 Clamp Installation.................................... 6
SECTION 4
Start-up and Operation
4.1 Preparing Diatomaceous Earth...............7
4.2 Coating the Filter Grids.......................... 7
4.3 New Pool and Seasonal Start-up............8
4.4 Valve Operation..................................... 8
SECTION 5
Filter Disassembly/Assembly
5.1 Filter Tank Disassembly/Assembly.............8
5.2 Filter Grid Disassembly/Assembly..............9
SECTION 6
Maintenance
6.1 General Maintenance....................,,,......... 9
6.2 Backwashing the Filter.............................. 10
6.3 Pressure Gauge......................................... 10
6.4 Cleaning the Filter Grids With Water....... 10
6.5 Cleaning the Filter Grids With
Muriatic Acid.................................................. 10
SECTION 7
Winterizing the Filter
7.1 Winterizing.......................................10
SECTION 8
Troubleshooting
8.1 Troubleshooting....................................... 11
SECTION 9
Exploded View and Parts List
9.1 Jandy® DEL Series Parts List.................... 12
9.2 Jandy® DEL Series Exploded View.......... 13
SECTION 10
Design Head Loss Curves
10.1 Design Head Loss Curves....................... 14