JANE KOOS iSIZE - FITTING the KOOS Isize ONTO YOUR JANÉ PUSHCHAIR; Hood

49
EN
I. FITTING THE KOOS iSIZE ONTO YOUR JANÉ
PUSHCHAIR
YourKOOSiSIZEcanbefastenedontoanyJANÉchassisttedwiththe
Pro-x connectors (always check the pushchair instructions before
ttingtheKOOSiSIZE).
Tofastenthesafetyseatontoachassis,insertthePro-xconnectors
intotheslotsinthechassisandpress.
5
.a YourKOOSiSIZEisfastened
correctlywhenyouhear it lockintoplace and a greenstrip is dis-
playedonthePro-xlever(foundonthehandlejoint).
5
.b
ToreleasetheKOOSiSIZEfromthechassis,simultaneouslypullthere-
leaseleversupwardsfoundonbothsidesofthechassisjointsandlift
thebabycarrierup.
5
.c
WARNING: The KOOS iSIZE should always be attached to the
pushchairsothebabyisfacingtheparent.
!
J. HOOD
ThehoodofyourKOOSiSIZEisdetachable.Simplyunfastentheelastic
cordsonthesidesoftheupholsteryandpullthesidesofthehoodarch
until itis free. Tot thehood again,follow the same stepsin reverse.
WARNING: The hood arch only has one possible assembly
position.Makesurethatthegreymarksonthearchandhandle
arealignedasshowninthediagram.
6
.
!