To Next PageTo Next Page
Need help?Do you have a question about the janitza Prophi 12RS and is the answer not in the manual?
General| Number of inputs | 12 |
|---|---|
| Protocol | Modbus RTU |
| Communication interface | RS-485 |
| Operating temperature | -10°C ... +55°C |
| Humidity | 5 ... 95% RH (non-condensing) |
Explains how to properly measure load and capacitor currents and set the current converter ratio.
Guides on adjusting phase correction between voltage and current, typically in Expert Mode 1.
Describes available error messages, alarm relay functions, and message relay programming.
Guides on automatically configuring the controller by recognizing system parameters for initial setup.
Explains manual programming steps for various parameters like language, converters, control series, and control principle.
Explains how to activate a programming lock to prevent unauthorized parameter changes.
Explains the test run function to check controller settings and capacitor output, including error detection.
Accesses the fault memory storing the last 50 fault states with fault codes and plain text descriptions.
Allows deactivation and setting of delay times for various operational, warning, and error messages.
