Janome Continental M7 Professional - Machine Operating Buttons; Start;Stop and Reverse Buttons

q
e
w
z
x
c
v
12
Preparation for Thread Cutter Switch
z Remove the cable tie q from the cable.
x If you wish to use the thread cutter switch, you need
to connect it with the foot control.
Insert the pin connector w into the jack e on the foot
control.
c Turn the foot control upside down.
Open the cover of the foot control.
v Draw out the cable from the foot control.
Thread Cutter Switch
If you wish to use the thread cutter switch, pull out the
cord from the foot control and insert the pin connector
into the jack on the machine.