Janome Continental M7 Professional - Needle Installation and Replacement; Attaching Darning Foot PD-H; Needle Replacement Procedure

q
e
t
t
r
y
r
w
e
21
Removing and Attaching the Foot Holder
Remove the foot holder before using Professional grade
foot HP, Ruler work foot QR, Darning foot PD-H, or Dual
feed foot AD.
CAUTION:
Always make sure to press the lockout key to lockout
the machine before replacing the foot holder.
Removing the foot holder
Raise the needle by pressing the needle up/down button.
Press the lockout key and raise the presser foot with the
presser foot lifter.
q Needle up/down button
w Lockout key
e Presser foot lifter
Loosen the setscrew and remove the foot holder.
r Setscrew
t Foot holder
Attaching the foot holder
Attach the foot holder to the presser bar from the rear.
Lower the presser foot with the presser foot lifter.
Tighten the thumbscrew securely with the screwdriver.
y Presser bar