JANOME Embroidery Software Instruction Book
Chapter 19 Advanced Digitizing Techniques
146
To remove underlying stitching
1 Select one or more ‘cutters’.
2 Select Edit > Remove Overlaps.
The stitching overlap is removed. A margin of overlap
is automatically calculated between cutter and
underlying object/s in order to avoid unsightly gaps.
Try this! You can use an entire design as a cutter
excluding objects, such as borders or details, less than
a certain width.
Filling holes in objects
The Fill Holes function fills holes in selected
Parallel Fill objects – excluding objects created with
the Parallel Fill Circle tool – either by removing
them altogether or by creating new objects based
on the holes in the original object. See also Cutting
holes in objects.
To fill holes in objects
1 Select the source object.
2 To use the default settings, simply click the Fill Holes
icon.
3 To control overlaps or remove holes altogether, select
Edit > Fill Holes.
The Fill Holes dialog opens.
4 Choose to remove holes altogether or create new
objects.
5 If you choose to create new objects, adjust the
Underlap value as required.
Overlap automatically
applied
Use Edit > Fill Holes to fill holes in selected
objects.
Adjust
underlap value
as required
To Next Page
Loading...