5
Chapter 2
System Setup
This chapter covers steps necessary to set up a new
JANOME Embroidery Software system on your PC. You
will also need to connect peripheral devices for use
with JANOME Embroidery Software including, of
course, your embroidery machine. Different devices
are set up in different ways – some in Windows, via
the Control Panel, others within JANOME Embroidery
Software itself. For instructions on connecting devices
to your computer and setting up in Windows, see the
documentation for the device as well as your Microsoft
Windows documentation.
Installation checklist
Use the following as a checklist of all necessary
steps to follow when installing and configuring your
new JANOME Embroidery Software software.
Step 1: Make sure your system meets the
minimum requirements. See Minimum
requirements for JANOME Embroidery Software for
details.
Step 2: When installing JANOME Embroidery
Software, read through all necessary installation
steps carefully before getting started.
Step 3: When the installation is complete, you
will be prompted to restart your computer.
Step 4: Attach your security dongle only when
prompted. If you have an existing version of the
software and have been provided with a new
‘upgrade dongle’, attach your old dongle as well.
See System security for details.
Step 5: Connect your machine to the PC. See
Supported machine models and memory cards for
details.
Step 6: If you are a new user, read carefully
through the introductory chapters in the onscreen
Instruction Book provided with your JANOME
Embroidery Software installation pack.
Step 7: Both new and existing users should
read through the onscreen Release Notes for an
understanding of new and improved features in
this software release. You can access the onscreen
Release Notes through the Help menu of your
JANOME Embroidery Software installation.
Minimum requirements for
JANOME Embroidery Software
To install JANOME Embroidery Software software
on your computer, it must meet the following
system requirements:
To Next Page
Loading...