JANOME Embroidery Software Instruction Book
Chapter 19 Advanced Digitizing Techniques
148
the Object Details dialog. Change these settings
before or after applying the effect. See Adjusting
Feather Edge settings for details.
To apply Feather Edge
Click the Feather Edge icon.
The effect is applied to new or selected objects, based
on the current Feather Edge settings.
Click Feather Edge again to remove the effect.
Adjusting Feather Edge settings
Adjust the Feather Edge settings to change the
amount of feathering, the side of the object to
which the effect is applied and the margin in which
the stitches should fall.
To adjust Feather Edge settings
1 Select and double-click the object.
The Object Details dialog opens.
2 Select the Feathering tab.
3 Select the Feathered checkbox.
4 Enter a Maximum Width for the feathering, this is the
margin in which the stitches will fall.
5 Use the Raggedness slider to indicate the required
degree of texture:
left for a smooth texture
right for a rough texture.
6 Select the Feathered Side checkbox you require: left
or right or both.
7 Click OK.
Click Edit > Feather Edge to apply the effect to
new or selected objects.
Range
Max. Width: 0.5mm Max. Width: 3.0mm
Raggedness: Low: less
variation in stitch length
Raggedness: High: more
variation in stitch length
To Next Page
Loading...