JANOME Embroidery Software Instruction Book
Chapter 22 Editing Embroidery Lettering
176
Reshape Circle CCW and Circle CW orientations
to change curve depth, justification point and
baseline length. See also Setting lettering
orientations.
To reshape a circular orientation
1 Select the lettering object.
2 Click the Reshape icon to display control points.
Try this! The large diamond and cross represent
stitching start and end points. You may need to move
them to access baseline control points. They will
reposition themselves in the new entry and exit points
based on the changes you make to the baseline.
3 To resize the circle drag up or down either the control
point on the circumference of the circle or in the center.
4 Create an arc baseline from a circular one by dragging
the hollow square control point apart.
5 Press
Esc to complete.
Reshaping custom orientations
Reshape Any Shape orientations by moving,
changing, adding or deleting control points along
the baseline. See also Setting lettering
orientations.
To reshape a custom orientation
1 Select the lettering object.
2 Click the Reshape icon to display control points.
Try this! The large diamond and cross represent
stitching start and end points. You may need to move
them to access baseline control points. They will
reposition themselves in the new entry and exit points
based on the changes you make to the baseline.
3 To adjust the baseline add, delete, change or move
reference points like any embroidery object. See
Reshaping objects for details.
4 To reshape the baseline, click the point on the baseline
where you want it to bend (change direction).
Left-click to bend the line at an angle.
Right-click to bend the line into a curve.
5 To re-position the baseline, drag any one of the
baseline control points up or down.
6 Press
Esc to complete.
Baseline control
points
Drag up or down to resize
the circle
Move the hollow square
control point apart
Use Edit > Reshape to reshape lettering
orientations.
Baseline control points
Click and drag the
baseline where you
want it to bend
Drag to change curvature
To Next Page
Loading...