JANOME Embroidery Software Instruction Book
Chapter 26 Outputting to Machine
205
File transfer begins. The selected design is copied to
the specified location.
Note In the unlikely event that a file exceeds the limits
set, it will be split into two or more files. See Splitting
large files for details.
Sending or receiving multiple designs
You can simultaneously send more than one design
in JEF file format to your machine. You can also
retrieve all designs from machine memory for
editing and/or to store them on hard disk or other
location. Alternatively, delete all designs from
machine memory to free up space.
To send or receive multiple designs
1 If you haven’t already done so, select MC11000 as your
current machine. See Supported machine models and
memory cards for details.
2 Insert the ATA PC card or USB stick into your JANOME
MemoryCraft machine if required.
Note Both ATA PC card and USB stick can be
attached at the same time.
3 Select Machine > Send Designs, Receive and
Delete.
The Send Designs, Receive and Delete dialog
opens. The dialog is divided in two sections – source
(PC) and destination (sewing machine).
Note The machine itself must be in PC-Link Mode in
order to receive designs.
4 Select a source folder from the PC list.
Only JEF files are displayed.
5 Select the file or files that you want to send in the
viewing panel.
6 Select a storage location on the sewing machine –
machine memory (built-in folder), ATA PC card, or USB
memory stick.
7 Click Send.
A confirmation box appears.
8 Click Start.
File transfer begins and selected designs are copied to
the selected location.
Note In the unlikely event that a file exceeds the limits
set, it will be split into two or more files. See Splitting
large files for details.
9 Select any files you want to receive or delete from the
destination folder.
10 Choose from the available options as required:
Click Receive to copy files from the machine to the
current location folder on your PC.
Click Delete to remove selected files from your
machine storage location.
Select files to
send
Use buttons to
navigate folders of
display file list
Select source
folder on your PC
Use buttons to
navigate folders or
file listing
Select storage
destination on your
sewing machine
Select files to
receive or delete
Receive or
delete files
from machine
location
To Next Page
Loading...