Janome DigitizerPro - Page 78

JANOME Embroidery Software Instruction Book
Chapter 10 Embroidery Stamps and Motifs
76
 To use the original size and orientation of the motif
press
Enter.
 To scale the motif, move the pointer until the motif is
the required size, click, then press
Enter.
Selecting motifs for motif runs
You can select motifs to use before or after
digitizing a motif run. If you use Motif Run without
selecting a motif, a default will be used. To change
a motif after digitizing, use the Object Details
dialog as described here.
Note For a complete catalog of samples, see
Stamps, Motifs and Border Samples.
To select a motif for motif runs
1 Double-click a Motif Run object.
The Object Details > Line Stitch > Motif Run dialog
opens.
2 Select a pattern from the dropdown list.
3 Click
OK.
The selected Motif Run object is updated according to
the motif selected.
Try this! Select a motif with no object selected and
click
OK to make the selection current.
Sizing and spacing motifs in motif runs
Set the exact size and spacing of motifs in a Motif
Run via the Object Details dialog before or after
digitizing.
To size and space motifs in a motif run
1 Double-click a Motif Run object.
The Object Details > Line Stitch > Motif Run dialog
opens.
Use Digitize > Motif Run to create a string of
motifs along a digitized line.
Resize motif
outline to scale
Use Digitize > Motif Run Line to create a string of
motifs along a digitized line.