Janome Sewist 500 - User Manual

Questions and Answers

P
Peter LawsonAug 3, 2025
Why does the needle thread break on my Janome Sewist 500 Sewing Machine?
- S
  Stacey MartinAug 3, 2025
  The needle thread may break on your Janome Sewing Machine due to several reasons: * The needle thread might not be threaded properly. * The needle thread tension could be too tight. * The needle might be bent or blunt. * The needle might be incorrectly inserted. * The needle thread and the bobbin thread might not be drawn to the rear and set properly under the presser foot when starting sewing. * The fabric might not be drawn to the rear when sewing is finished. * The thread might be too heavy or too fine for the needle.
K
kthompsonAug 8, 2025
Why am I getting skipped stitches with my Janome Sewist 500?
- L
  Laurie WoodAug 8, 2025
  Skipped stitches on your Janome Sewing Machine can occur because: * The needle is incorrectly inserted. * The needle is bent or blunt. * The needle and/or thread are not suitable for the fabric being sewn. * A blue tip needle is not used for sewing stretch, very fine fabrics and synthetics. * The needle thread is not threaded properly. * A poor quality needle is used; consider replacing the needle.
W
William CoffeyAug 12, 2025
Why does the bobbin thread keep breaking on my Janome Sewist 500?
- J
  Jennifer PrattAug 12, 2025
  The bobbin thread on your Janome Sewing Machine may break if: * The bobbin thread is not threaded properly in the bobbin holder. * Lint has collected in the bobbin holder. * The bobbin is damaged and does not turn smoothly; replace the bobbin. * The thread is wound loosely on the bobbin; re-wind the bobbin.
M
martinheatherAug 16, 2025
Why is my Janome Sewist 500 Sewing Machine so noisy?
- E
  Elizabeth SnyderAug 16, 2025
  Noisy operation of your Janome Sewing Machine may be caused by: * The feed dog being packed with lint. * Lint having collected in the bobbin holder.
C
Christian ParkerAug 20, 2025
Why is there seam puckering when I sew with my Janome Sewing Machine?
- D
  David MelendezAug 20, 2025
  Seam puckering on your Janome Sewing Machine can occur if: * The needle thread tension is too tight. * The needle thread is not threaded properly. * The needle is too heavy for the fabric being sewn. * The stitch length is too long for the fabric; try making the stitch shorter. * A stabilizer may be needed for very fine fabrics.
P
Peter NelsonAug 25, 2025
What to do if the cloth is not feeding smoothly on my Janome Sewing Machine?
- J
  John TaylorAug 25, 2025
  If the cloth is not fed smoothly through your Janome Sewing Machine, it could be due to: * The feed dog being packed with lint. * The stitches being too fine; try making the stitch longer. * The feed dog not being raised after being lowered. * The foot pressure not being adjusted properly.
B
Billy PachecoAug 29, 2025
Why is the needle thread looping on my Janome Sewist 500?
- C
  christensenjamesAug 29, 2025
  The needle thread on your Janome Sewing Machine may loop if: * The needle thread tension is too loose. * The needle size is not suitable for the thread.