IMPORTANT INSTALLATION SAFETY
THE FOLLOWING SAFETY INSTRUCTIONS RELATE TO THE INSTALLATION OF
THE PANTHEON COMMERCIAL ROLLING DOOR OPERATOR
WARNING !! —TO REDUCE THE RISK OF DEATH OR SEVERE INJURY ALL OF
THE FOLLOWING INSTRUCTIONS MUST BE READ, ACKNOWLEDGED AND
ADHERED TO.
x DO NOT allow children or unauthorized persons in or about the work area when
performing the installation or testing of the rolling door and operator.
x DO NOT attempt to install the rolling door unless you have read , understood and
acknowledged the installation instructions provided for the commercial rolling door.
x DO NOT attempt to install or commission the Pantheon operator or any
accessories unless you have read, understood and acknowledged the instructions
provided.
x ENSURE that all electrical connections for mains power supply are made in
accordance with local and NEC wiring codes.
x ENSURE that the commercial rolling door is installed with correct spring tension
and side clearances—the commercial rolling door must operate in the manual
condition without binding or sticking in the guides.
x INSTALL the logic controller in a suitable location—at a minimum of five (5) feet
from the ground and maximum of three (3) feet from the edge of the opening and
in clear sight of the surrounding areas.
x OBSERVE local and national safety codes—including but not limited to UL325—
when connecting external accessories and any requirement for the installation of
an external entrapment device.
x REMOVE or render inoperable any manually operated locks that may be fitted to
the commercial rolling door.
x REMOVE the factory fitted “test plug” unless required for the purposes of
supervised operation and testing during the installation process.
x ALWAYS complete the commissioning and handover check list and ensure that
the client, site manager or authorized representative is fully instructed in the safe
operation of the commercial rolling door and operator.
x REFER any technical problems or enquiries relating to the commercial rolling door
or the operator to the manufacturer (Janus International ).
To Next Page
Loading...
Need help?
General
