Janus 2000 - User Manual

1
www.janusintl.com
JANUS INTERNATIONAL GROUP LLC
135 JANUS INTERNATIONAL BLVD.
TEMPLE, GA 30179
PHONE 770-562-2850 / FAX 770-562-1991
2000 INSTALLATION GUIDE
Rev. Date: 5/27/2020
810014-0001
IMPORTANT INFORMATION
JANUS INTERNATIONAL DOORS MUST BE INSTALLED BY TRAINED ROLLING DOOR TECHNICIANS QUALIFIED TO INSTALL
PRODUCT SAFELY WITH PROPER KNOWLEDGE, TOOLS, SAFETY AND INSTALLATION EQUIPMENT. CAREFULLY READ
INSTALLATION INSTRUCTIONS. FAMILIARIZE YOURSELF WITH ALL INSTALLATION PROCEDURES, WARNINGS, CAUTIONS, AND
NOTES BEFORE ATTEMPTING TO INSTALL DOOR. JANUS INTERNATIONAL CORPORATION WILL NOT WARRANTY OR ACCEPT
RESPONSIBILITY FOR DOORS NOT INSTALLED PER THESE INSTALLATION INSTRUCTIONS.
O & M Manual

Janus 2000 Specifications

General

Brand	Janus
Model	2000
Category	Garage Door Opener
Language	English

Summary

Important Information

Installation Requirements

Janus International doors must be installed by trained technicians.

Important Safety Information

Pre-Installation Inspection

Inspect received door assembly for damage and shortages.

Installer Competency

Do not attempt installation if unfamiliar or uncomfortable with procedures.

Step 1: Wall Opening

Wall Opening Verification

Check width, height, jamb plumb, and header level for installation.

Step 2: Mounting Plates

Mounting Plate Positioning

Step 3: Commercial Brackets to Guides

Bracket Attachment to Guides

Attach commercial brackets 2" below top of guide using specified hardware.

Drive End Configuration

Step 4: Guides and Brackets to Jamb

Wall Fastener Selection

Step 14: Setting Initial Spring Tension

Step 18: Check Door Operation

Step 19: Adjust Spring Tension (if required)

Step 20: Product Safety Labels

RDD-202 Rolling Door Safety Label

RDD-201 Tension Safety Label

RDD-204 Rolling Door Bottom Bar Label

Rolling Sheet Door Performance Evaluation

Visual Inspection