APTX - For lose-less audio wireless streaming
NFC for Bluetooth® pairing
Lightning Connector
True Wireless for wireless stereo mode
Line-in 3.5 mm port
Micro USB for Firmware update.
IR remote with backlight
AeroBull HD® Quick Start
To start, plug the AeroBull HD® to the power supply and then plug the AC adaptor to the socket. To Power ON press and hold for about one
second the power button located at the back of the speaker.
(image how to plug the socket)
On Power ON the white LED will turn ON. After Powered on, the product will automatically go into Bluetooth pairing mode. The Blue LED located
by the paw will start blinking to indicate that the AeroBull HD® Bluetooth is ON and ready to connect.
4.1.Using Bluetooth
To stream music to the AeroBull HD® using Bluetooth simply connect your Bluetooth device to the AeroBull HD® and press play on you device.
4.1.1.Connect to iPhone® or iPod®
To enable this feature, perform the following steps (image how to connect via Bluetooth iOS)
Go to Settings on your iOS device.
Look for General in the list
Then under General go to Bluetooth;
Make sure Bluetooth is On;
Under Devices you should see something like this BULL_XXXXXX_XXNot Paired (X stands for letters or number, this may change for
each device).
Tap the list item BULL_XXXXXX_XXto connect. Your device will show that AeroBull HD® is connected.
4.1.2.Connect to Android Phones
To use this feature, perform the following steps:
Go to Settings.
Tap on Bluetooth.
Turn On the Bluetooth if is not already ON.
Look for AeroBull HD® in the list of Available Devices.
Tap on the list item AeroBull HD® to pair and connect.
4.1.3.Connect to your Apple® Laptop or Desktop
Turn on Bluetooth on your computer.
On the Desktop top navigation bar click on the Bluetooth icon and from the Bluetooth dropdown selectSet Up Bluetooth Device.
From the list of devices select AeroBull HD® and press Continue, wait for the confirmation message.
Go back to the Bluetooth dropdown on the navigation bar.
Roll over the AeroBull HD® on the list, another dropdown will appear.
SelectUse as Audio Device.
Now you can play the audio on your computer directly from the speaker.
Once connected the Bluetooth the Blue Led light will turn on.
4.1.4. Connect Using NFC
If your device supports NFC just tap your device on the top part of the AeroBull HD® until you hear the pairing sound or you will receive a
message on screen on your device that the AeroBull HD® was successfully paired.
(image: AeroBull HD® NFC pairing)
Operating the AeroBull HD®
Volume Control
To Next Page
Loading...