Jasic Cut 45 - Plasma Machine Gas Supply - Compressed Air; Compressor Selection and Accessories

16
Only use compressed air with the Jasic plasma machines
Please Note: NEVER USE OXYGEN
Compressed Air Supplies
Sizing the appropriate compressor to use with your plasma cung machine is as important as supplying
the correct mains power supply.
To get the best out of your plasma cuer you need to supply it with an adequate air supply. The below
are suggested quesons that need to be considered when specifying an air compressor.
• What is the maximum required operang pressure of the plasma cuer?
• What is the maximum required CFM usage of the plasma cuer?
• Does the machine need to be portable or staonary?
• What type of drive do you require? Electric motor or diesel engine?
• What receiver tank size will be needed?
• Generally 3 phase compressors are considered a beer opon than single phase compressors.
The accessories used with the compressor are also important, providing the correct air pressure, air ow which is moisture and oil free is
crucial in ensuring that your plasma will give you quality cuts.
Air Hose: Remember to select the correct bore size, considering demand and length.
Filters: Remove contaminants e.g. water and oil thus prolonging plasma torch consumable life.
Dryers: Refrigerant dryers, high eciency heat exchangers.
Regulators: Allow adjustment to opmum pressure for ecient use of your plasma cuer. Regulate your system to the pressure you need.
Couplings: Heavy air use tools/equipment may need high ow couplings. Size maers.
PLEASE NOTE: Using oxygen in a plasma torch that is designed for air cung can cause a serious re and injury.
Be careful and always follow the manufacturer’s instrucons.
Plasma Machine Gas Supply - Compressed Air
Wilkinson Star Technical