Jasic Cut 45 - PT60 Torch Information and Fitting

7
PT60 Plasma Hand Torch
Wilkinson Star Technical
The PT60 plasma torch supplied has the ‘euro style’ power/gas connecon, pilot cable and switch pins connecons.
All Jasic plasma cung systems and torches supplied incorporate a safety circuit to prevent operator injury when
changing consumables etc. This is a simple ring circuit that breaks the electrical torch switching as soon as the
retaining cap is removed prevenng machine operaon. Without such a protecon circuit as previously menoned
the open circuit voltage could be as high as 350V DC at the torch head.
The torch head encompasses a full set of consumables as shown right, these consumables are made
up of a cooling tube, torch electrode, swirl ring for gas distribuon, cung p, retaining cap and if
required a stand o device to ensure the same distance between p and material being cut.
Fing the PT60 plasma torch
On the Jasic Cut 45 plasma machine, the below torch ng instrucons
will need to be observed.
• Locate plasma torch plug into euro connector socket as shown in
image 1 below
• Push the torch (image 1) whilst at the same me rotate the locking
nut on torch clockwise unl fully connected and ght as in image 2
below
Image 1 Image
2
Plasma Torch Connecon Diagram