Jasic MIG 270 Separate - Page 5

A WILKINSON STAR PRODUCT 10-17 ISSUE 3
Never use broken or faulty welding helmets.
Always ensure there are adequate protecve
screens or barriers to protect others from ash,
glare and sparks from the welding area. Ensure
that there are adequate warnings that welding or
cung is taking place.
Wear suitable protecve ame resistant clothing.
The sparks and spaer from welding, hot work
pieces, and hot equipment can cause res and
burns
Welding on closed containers, such as tanks,
drums, or pipes, can cause them to explode.
Accidental contact of electrode to metal objects
can cause arcs, explosion, overheang, or re.
Check and be sure the area is safe and clear of
inammable material before carrying out any
welding.
Protecon against noise
Some welding and cung operaons may produce
noise.
Wear safety ear protecon to protect your hearing.
Protecon from moving parts
When the machine is in operaon keep away from
moving parts such as motors and fans. Moving
parts, such as the fan, may cut ngers and hands
and snag garments.
Protecons and coverings may be removed for
maintenance and controls only by qualied
personnel, aer rst disconnecng the power
supply cable.
Replace the coverings and protecons and close all
doors when the intervenon is nished, and before
starng the equipment.
Take care to avoid geng ngers trapped when
loading and feeding wire during set up and
operaon.
When feeding wire be careful to avoid poinng it at
other people or toward your body.
Always ensure machine covers and protecve
devices are in operaon.
Precauons against re and explosion
Avoid causing res due to sparks and hot waste or
molten metal
Ensure that appropriate re safety devices are
available near the cung / welding area.
Remove all ammable and combusble materials
from the cung / welding zone and surrounding
areas
Do not cut/weld fuel and lubricant containers, even
if empty.
These must be carefully cleaned before they can be
cut/ welded.
Always allow the cut/welded material to cool
before touching it or placing it in contact with
combusble or ammable material.
Do not work in atmospheres with high
concentraons of combusble fumes, ammable
gases and dust.
Always check the work area half an hour aer
cung to make sure that no res have begun.
Risks due to magnec elds
The magnec elds created by high currents may
aect the operaon of pacemakers or
electronically controlled medical equipment.
Wearers of vital electronic equipment should
consult their physician before beginning any arc
welding, cung, gouging or spot welding
operaons.
Do not go near welding equipment with any
sensive electronic equipment as the magnec
elds may cause damage.
RF Declaraon
Equipment that complies with direcve 2004/108/
EC concerning electromagnec compability (EMC)
and the technical requirements of EN60974-10 is
designed for use in industrial buildings and not