Jasic MIG 270 Separate - Product Overview

A WILKINSON STAR PRODUCT 10-17 ISSUE 3
those for domesc use where electricity is provided
via the low voltage public distribuon system.
Dicules may arise in assuring class A
electromagnec compability for systems installed
in domesc locaons due to conducted and
radiated emissions.
In the case of electromagnec problems, it is the
responsibility of the user to resolve the situaon. It
may be necessary to shield the equipment and t
suitable lters on the mains supply.
LF Declaraon
Consult the data plate on the equipment for the
power supply requirements.
Due to the elevated absorbance of the primary
current from the power supply network, high power
systems aect the quality of power provided by the
network. Consequently, connecon restricons or
maximum impedance requirements permied by
the network at the public network connecon point
must be applied to these systems.
In this case the installer or the user is responsible
for ensuring the equipment can be connected,
consulng the electricity provider if necessary.
Materials and their disposal
The equipment is manufactured with materials,
which do not contain any toxic or poisonous
materials dangerous to the operator.
When the equipment is scrapped, it should be
dismantled separang components according to the
type of materials.
Do not dispose of the equipment with normal
waste. The European Direcve 2002/96/EC on
Waste Electrical and Electronic Equipment states
the electrical equipment that has reached its end of
life must be collected separately and returned to an
environmentally compable recycling facility.
Handling of Compressed gas cylinders and
regulators
All cylinders and pressure regulators used in
welding operaons should be handled with care.
Never allow the electrode, electrode holder or any
other electrically “hot” parts to touch a cylinder.
Keep your head and face away from the cylinder
valve outlet when opening the cylinder valve.
Always secure the cylinder safely
Never deface or alter any cylinder
3 PRODUCT OVERVIEW
The MIG Series is a range of single and three phase
inverter power sources with separate wire feed unit
is a range that can provide MIG, MMA and gas less
self- shielded welding opons. With the wire feed
interconnecons it canbe used to weld in a wide
radius.
The IGBT power devices with unique control mode
provides excellent reliability with a high duty cycle.
The system has a closed loop feedback control,
constant voltage output, which allows it to operate
with a wide tolerance to mains uctuaon, within
±15%.
They have connuously adjustable welding voltage
and current, to provide excellent welding
characteriscs.
Adopng a unique welding dynamic characterisc
control circuit in MIG, provides a stable arc, low
spaer, excellent weld appearance and high
welding eciency.
By removing the ball at the end of the wire aer
welding, a high no-load voltage, and slow wire feed
at the start presents exceponal arc starng.
The machines also have a very stable welding
current in MMA, excellent arc ignion, and can be
used with a wide variety of welding electrodes.
Their high inverter frequency greatly reduces the
volume and weight of the welder and the great
reducon in magnec and resistance loss obviously
enhances the welding eciency and energy saving
eect.
Switching frequency is beyond audio range, which
almost eliminates noise polluon.