OPERATOR’S MANUAL · MIG/MAG PULSE SERIES
5.2 Details of the functional zones on the power supply monitoring panel
Figure 5.2: Welding mode selecting zone
It contains components such as welding mode
LEDs and selecting key.
There are 4 welding modes, namely standard
MIG/MAG, pulsed MIG/MAG, Double pulse MIG/MAG
and MMA. Users can select the desired welding
mode by pressing the selecting key, and the
corresponding LED will be on when a certain
welding mode is selected.
Note: The welding mode LED blinks during
welding (when there is welding current output).
Figure 5.3: Base metal selecting zone
It contains components such as base metal LEDs
and selecting key.
Base metal includes carbon steel, stainless
steel, aluminum alloy, aluminum magnesium alloy,
pure aluminum . Users can select the desired base
metal by pressing the selecting key, and the
corresponding LED will be on when a certain kind
of base metal is selected.
Note: There is no such function in MMA .
Figure 5.4: Gas selecting zone
It contains components such as gas LEDs and
selecting key.
Gas includes 100% CO2, 80% Ar+20% CO2, 90% Ar+5%
CO2+5% O2, 98% Ar+2% CO2 and 100% Ar . Users can
select the desired shield gas by pressing the
selecting key, and the corresponding LED will
be on when a certain kind of shield gas is
selected.
Note:There is no such function in MMA .
Figure 5.5: Wire diameter selecting zone
It contains components such as welding wire LEDs
and selecting key.
Welding wire includes solid wire of Φ0.8, Φ1.0,
Φ1.2 andΦ1.6, flux-cored wire ofΦ1.0, Φ1.2
and Φ1.6 and Flux cored. Users can select the
desired wire by pressing the selecting key, and
the corresponding LED will be on when a certain
kind of wire is selected. The flux-cored wire LED
on indicates that flux-cored wire is selected,
while the LED off indicates that solid wire is
selected.
Note: There is no such function in MMA .
To Next Page
Loading...
