Need help?Do you have a question about the Jasic MIG250P and is the answer not in the manual?
General| Brand | Jasic |
|---|---|
| Model | MIG250P |
| Category | Welding System |
| Language | English |
Inverter technology for reduced volume, weight, and noise.
Closed loop feedback control for stable output and voltage fluctuation resistance.
Synergic MIG, multiple welding modes, and protective functions.
Identifies components on the front panel of the welder.
Details the back panel components and button descriptions.
Steps for installing the MIG welding machine.
Visual guide for installation and operation details.
Describes two modes for wire feeder operation during welding.
How to adjust wire feed speed and voltage for welding current and voltage.
Explains the function of the inductance button for arc characteristic adjustment.
Details the 2-stroke and 4-stroke welding operation modes.
Information on selecting shielding gases for MAG and CO2 welding.
Guidance on welding current, speed, and gas flow selection.
Tables for I-type butt, fillet (flat/vertical), and stitch welding parameters.
Parameters for MAG welding with mixed gas (Ar+CO2).
Steps for installing the MMA welding machine.
Visual guide for MMA welding machine installation.
Steps for operating the MMA welding machine.
Quick reference for MMA welding parameters based on electrode diameter.
Explains the fault indicator and its behavior under abnormal circumstances.
Lists and describes common fault codes and their causes.
Guidelines for operating the welder in suitable environmental conditions.
Importance and requirements for proper ventilation for the welder.
Explanation of overload protection mechanism and behavior.
Details on over-current protection for the gas heater power supply.
Advice on preventing the welding source from toppling.
Guidelines and checks for regular repair and maintenance of the welder.
Table for common failures, causes, and troubleshooting solutions.
To Next Page
