To Next Page
A
angela03Sep 13, 2025
Why does my Jasic Welding System show overheat error?
- TTheresa BakerSep 13, 2025
If the Jasic Welding System is overheating, ensure proper airflow around the machine. If the cooling fan is not running, repair or replace it.
Why does my Jasic Welding System show overheat error?
If the Jasic Welding System is overheating, ensure proper airflow around the machine. If the cooling fan is not running, repair or replace it.
Why is there no gas flow when I depress the MIG torch trigger switch on my Jasic MIG?
If there's no gas flow when you press the MIG torch trigger switch, consider these possibilities: * The gas cylinder might be empty, so replace it. * The gas regulator might be turned off; turn it on. * The gas hose could be blocked or cut; inspect and replace it if necessary. * The torch trigger switch lead might be disconnected or faulty; reconnect or replace it.
What to do if the fault LED is ON and the fan is running on my Jasic Welding System?
If the fault LED is on and the fan is running, it could be due to: The machine is under over-heating protection status. Allow the machine to cool; it can recover automatically. Also, check incoming mains supply to ensure it is within 230V +/- 15%.
Why does the Jasic MIG overheat LED light up?
The overheat LED might light up because of insufficient cooling air. In this case, let the machine cool, and it will automatically start again. Another reason may be that the cooling fan is not running, check and repair the cooling fan.
What does error code ‘Err 1’ mean on Jasic Welding System?
If the Jasic Welding System displays the error code ‘Err 1’, it indicates that the mains input voltage is too low. Check the mains supply to ensure it meets the required voltage.
What to do if wire feeder does not work with Jasic MIG Welding System?
If there is output current when pushing the torch trigger to feed gas, but the wire feeder does not work with your Jasic Welding System, the wire feeder may be clogged. Unclog it.
Why is there no response when pushing the torch trigger on my Jasic MIG Welding System?
If there is no response when pushing the torch trigger on your Jasic Welding System and the alarm indicator does not illuminate, the torch trigger may have failed. Repair or replace the welding torch.
Why the fan does not work during welding with Jasic Welding System?
If the fan isn't working during welding with your Jasic Welding System, ensure the power cord for the fan is securely connected. If it is, auxiliary power may have failed, and you should ask professionals to check.
Why is the welding current unstable in my Jasic Welding System?
Unstable welding current in your Jasic Welding System can stem from several causes. The wire feeder may be failing, or the control PCB or wire feeding power PCB inside the machine could be faulty, in which case you should repair or replace it. Check the pressure arm on the wire feeder and adjust it properly. Ensure the drive roll matches the wire size being used. A badly worn contact tip or wire-feeding tube on the welding torch can also cause this issue, so replace them if necessary. Finally, using a poor-quality electrode can lead to instability, so switch to a good quality electrode.
What causes excessive spatter in MMA welding with my Jasic MIG Welding System?
Excessive spatter in MMA welding can be caused by incorrect output polarity connection. Exchange the polarity.
General| Brand | Jasic |
|---|---|
| Model | MIG SERIES |
| Category | Welding System |
| Language | English |
