1. INTRODUCTION
1.1 How To Use This Manual
To ensure safe operation, read the entire manual, including the chapter on safety instructions and warnings.
1.2 Receipt of Equipment
When you receive the equipment , check it against the invoice to make sure it is complete and inspect the
equipment for possible damage due to shipping. If there is any damage, notify the carrier immediately to file
a claim. Furnish complete information concerning damage claims or shipping errors to the location in your
area listed in the inside back cover of this manual. Include all equipment identification numbers along with a
full description of the parts in error. Move the equipment to the installation site before un-crating the unit.
Use care to avoid damaging the equipment when suing bars , hammers, etc., to nu-crate the unit.
1.3 Description
The machine takes the guess work out of welding with an impressive SYNERGIC SET function that allows
the user to weld like a Pro with no previous welding experience necessary.
1.4 User Responsibility
This equipment will perform as per the information contained herein when installed, operated, maintained
and repaired in accordance with the instructions provided. This equipment must be checked periodically.
Defective equipment (including welding leads) should not be used. Parts that are broken, missing, plainly
worn, distorted or contaminated, should be replaced immediately. Should such repairs or replacements
become necessary, it is recommended that such repairs be carried out by appropriately qualified persons
approved by JASIC. Advice in this regard can be obtained by contacting an Accredited JASIC distributor.
This equipment or any of its parts should not be altered from standard specification without prior written
approval of JASIC. The user of this equipment shall have the sole responsibility for any malfunction which
results from improper use of unauthorized modification from standard specification, faulty maintenance,
damage or improper repair by anyone other than appropriately qualified persons approved by JASIC.
1.5 Packaged Items
• Inverter Power Source
• MIG Torch,2M
• Feed rolls: 0.8/0.9mm “K” knurled or 0.030/0.035inches “K” knurled (only for FCAW)
0.6/0.8mm “V” Groove (only for GMAW)
• Work Clamp with 1m or 1.5m or 2m Lead
• Shoulder Strap
• Operating Manual
To Next Page
Loading...
