Jasic Plasma Cut 80 - Page 5

A WILKINSON STAR LIMITED PRODUCT 12-16 ISSUE 1
Always ensure machine covers and protecve devices are in operaon.
Precauons against re and explosion
Avoid causing res due to sparks and hot waste or molten metal
Ensure that appropriate re safety devices are available near the cung / welding area.
Remove all ammable and combusble materials from the cung / welding zone and surrounding areas
Do not cut/weld fuel and lubricant containers, even if empty.
These must be carefully cleaned before they can be cut/ welded.
Always allow the cut/welded material to cool before touching it or placing it in contact with combusble
or ammable material.
Do not work in atmospheres with high concentraons of combusble fumes, ammable gases and dust.
Always check the work area half an hour aer cung to make sure that no res have begun.
Risks due to magnec elds
The magnec elds created by high currents may aect the operaon of pacemakers or electronically
controlled medical equipment.
Wearers of vital electronic equipment should consult their physician before beginning any arc welding,
cung, gouging or spot welding operaons.
Do not go near welding equipment with any sensive electronic equipment as the magnec elds may
cause damage.
RF Declaraon
Equipment that complies with direcve 2004/108/EC concerning electromagnec compability (EMC)
and the technical requirements of EN60974-10 is designed for use in industrial buildings and not those for
domesc use where electricity is provided via the low voltage public distribuon system. Dicules may
arise in assuring class A electromagnec compability for systems installed in domesc locaons due to
conducted and radiated emissions.
In the case of electromagnec problems, it is the responsibility of the user to resolve the situaon. It may
be necessary to shield the equipment and t suitable lters on the mains supply.
LF Declaraon
Consult the data plate on the equipment for the power supply requirements.
Due to the elevated absorbance of the primary current from the power supply network, high power
systems aect the quality of power provided by the network. Consequently, connecon restricons or
maximum impedance requirements permied by the network at the public network connecon point
must be applied to these systems.
In this case the installer or the user is responsible for ensuring the equipment can be connected,
consulng the electricity provider if necessary.
Materials and their disposal
The equipment is manufactured with materials, which do not contain any toxic or poisonous materials