What to do if a wire becomes loose in my Jasic Welding System?
If a wire becomes loose or is misplaced, it presents a potential danger to the user. Only professional maintenance personnel should repair the Jasic Welding System!
General| Input Frequency | 50/60Hz |
|---|---|
| Output Current Range | 10 - 200A |
| Output Current | 200A |
| Rated Output Voltage | 28V |
| Duty Cycle | 60% |
| Efficiency | 85% |
| Power Factor | 0.93 |
| Insulation Class | F |
| Protection Class | IP21S |
| PFC (Power Factor Correction) | Yes |
Ensures safe electrical connections and practices during operation.
Precautions for safe handling, movement, and environmental considerations.
Essential protective gear for welding operations.
Information on health risks and controls for welding fumes and gases.
Guidelines to prevent fires and explosions during welding.
Safe practices for handling and storing gas cylinders and regulators.
Explanation of digital ammeter, switches, LEDs, and terminals.
Guidance on connecting power supply and welding leads.
Explanation of the MMA process, electrode coating, and weld bead formation.
Table of defects like spatter, porosity, penetration, with causes and solutions.
Lists faults like no arc, difficult ignition, and LED indicators with possible causes/actions.
To Next Page
