pre-ride safety checklist.
Pre-Ride Safety Checklist
1.Brakes
2.Wheels and Tires
3.Steering
4. Chain
damage.
Perform a handlebar twist test (see assembly step 4) to ensure the stem clamp bolt security.
5. Bearings
6. Cranks and
Pedals
7. Derailleur and
Mechanical
Cables
Safety Check
Ensure front and rear brakes work properly.
Check brake pads for wear and ensure they are not overworn.
Ensure brake pads are correctly positioned in relation to the rims.
Ensure brake levers are lubricated and tightly secured to the handlebar.
are functioning properly.
Seat
9. Motor Drive
Assembly and
11. Electrical Cables
Check that the frame and fork are not bent or broken.
Ensure hub motor is spinning smoothly and motor bearings are in good working order.
Ensure all power cables running to hub motor are secured and undamaged.
washers are in place.
Let bike dry completely before using again.
Look over connectors to make sure they are fully seated and free from debris or moisture.
Check cables and cable housing for obvious signs of damage.
12. Accessories
Inspect helmet and other safety gear for signs of damage.
Ensure there are no cracks or holes in fenders.
removed before every ride.
Your cables, spokes, and chain will stretch after an initial break-in period of 50-100 mi
(80-160 km), and bolted connections can loosen. Always have a certified, reputable bike
mechanic perform a tune-up on your bike after your initial break-in period of 50-100 mi
(80-160 km) (depending on riding conditions such as total weight, riding characteristics,
and terrain). Regular inspections and tune-ups are particularly important for ensuring
that your bike remains safe and fun to ride.
Safety Check
29
30
To Next Page
Loading...
