Tire Inflation and Replacement
visit www.jasionride.com or contact Jasion Support Team.
Email: support@jasionride.com
35 PSI
It is critically important that proper air pressure is always maintained in pneumatic tires. Do not underinflate or overinflate your
tires. Low pressure may result in loss of control, and overinflated tires may burst. Failure to always maintain the air pressure
rating indicated on pneumatic tires may result in tire and/or wheel failure.
When changing a tire or tube, ensure that all air pressure has been removed from the inner tube prior to removing the tire from
the rim. Failure to remove all air pressure from the inner tube could result in serious injury.
Using aftermarket tires or inner tubes, not provided by jasion may void your warranty, create an unsafe riding
condition, or damage to your bike. If required by law, ensure replacement aftermarket tires have sufficient reflective sidewall
striping.
Inflate your tires from a regulated air source with an available pressure gauge. Inflating your tires from an unregulated air source
could overinflate them, resulting in a burst tire.
1
2
The bike does not
work
speed
3. Misaligned or damaged magnet ring
The motor does not
respond when the
bike is powered on
Reduced range
charge
Wheel or motor
makes strange noises
5. Brakes are applied
6. Blown discharge fuse
2. Clean and repair connectors
5. Disengage brakes
6. Replace discharge fuse
3. Align or replace magnet ring
1. Repair and or reconnect
2. Tighten or replace
3. Secure or replace
4. Repair or replace
3. Assist with pedals or adjust route
Support if range decline persists
5. Adjust the brakes
2. Replace
3. Replace
4. Repair or replace
5. Replace charge fuse
2. Reconnect or replace motor.
1. Loose wiring
3. Loose or damaged motor plug wire
4. Damaged motor
excessive load
5. Brakes rubbing
1. Charger not well connected
2. Charger damaged
4. Wiring damaged
5. Blown charge fuse
1. Loose or damaged wheel spokes or rim
2. Loose or damaged motor wiring
3
4
5
6
Symptoms Possible Causes
31
32