Assembly
4. Install the front wheel bearing nut covers.
3. Tighten the nut on the fork with wrench.
front wheel to align the axle at the center of the
wheel with the center of front dropout.
Note:
nut should be fully and properly secured. Ensure the front wheel
are properly secured before moving on to the next step.
1 2
3 4
1. Locate the disk brake. Remove the two screws.
the brake pads in the brake caliper.
4.Hold the cable to the frame with the clip.
2.Clamp the rotor between the two brake blocks.
Assembly
Note:
10
9
To Next Page
Loading...
