JAVAC CC-231 - User Manual

Other manuals for JAVAC CC-231

Safety Instructions & Operation Manual28 pages

Questions and Answers

R
Richard BarronAug 9, 2025
What to do if my JAVAC CC-231 Water Pump has poor vacuum?
- Y
  yschultzAug 9, 2025
  If your JAVAC Water Pump isn't creating a good vacuum, several factors could be the cause. First, check the oil level and add oil to the center line of the oil scale if it's insufficient. If the oil is emulsified or not clean, replace it with new oil. Also, inspect the oil inlet and filtering screen, cleaning them if blocked. Examine the pump hose and vessel for any leaks and repair them. Ensure you're using the correct size pump; if it's too small, use a larger one. Finally, worn components can cause poor vacuum, so consider repairing or replacing the pump.
S
shelley51Aug 15, 2025
Why is my JAVAC CC-231 Water Pump overheating?
- M
  molinamichaelaAug 15, 2025
  If your JAVAC Water Pump is overheating, there could be a few reasons: * If the temperature is below +5C, allow the temperature to rise. * If the motor is overloaded, wait 5 minutes and restart it, or press the motor reset if installed. * Check for any foreign matter that may have fallen into the pump and eliminate it.
J
jeffrey92Aug 20, 2025
What to do if my JAVAC CC-231 Water Pump is discharging oil?
- R
  rhondamoralesAug 21, 2025
  If your JAVAC Water Pump is discharging oil, it could be due to a couple of reasons. First, there might be too much oil in the pump; in this case, drain the oil to the oil base line on the sight glass. Alternatively, the inlet pressure could be too high, so use a recovery pump to remove the excess pressure.
M
Michael AguirreAug 27, 2025
Why is my JAVAC Water Pump leaking oil?
- K
  Kathleen LeeAug 27, 2025
  If your JAVAC Water Pump is leaking oil, it could be due to a damaged oil seal, which would need to be replaced with a new one. Alternatively, the oil casing gasket might be loose or damaged. Try tightening the screws, or replace the O-type ring if necessary.
S
scottjuanSep 1, 2025
How to fix a JAVAC CC-231 Water Pump that is difficult to start?
- R
  randypaceSep 1, 2025
  If your JAVAC Water Pump is having difficulty starting, it could be due to low voltage; avoid using long extension leads. Another reason could be that the pump is overheated, so check the fan and ventilation, and repair if needed. If you are in any doubt, consult JAVAC.