Do you have a question about the Jawbone Icon and is the answer not in the manual?
Bluetooth Version | 2.1 + EDR |
---|---|
Noise Cancellation | Yes |
Talk Time | Up to 4.5 hours |
Standby Time | Up to 10 days |
Wireless Range | 33 feet |
Multipoint Technology | Yes |
Voice Prompts | Yes |
Compatibility | Bluetooth-enabled devices |
Press and hold TALK BUTTON while sliding on Jawbone until LED flashes RED + WHITE for pairing mode.
Turn on Bluetooth settings on your iPhone, Blackberry, or other cell phones for connection.
Go to phone's Bluetooth settings, search for "Jawbone ICON", and enter passcode "0000" if prompted.
Mix and match earpieces for the most comfortable and secure fit, with or without an earloop.
Place Jawbone in ear pointing down, then twist upwards to point at mouth for optimal positioning.
Press the TALK BUTTON to answer incoming calls and press again to hang up.
Use your phone to dial and talk through your Jawbone. Press TALK BUTTON to hang up.
Charge Jawbone; LED flashes RED when low, turns WHITE when fully charged.