103721 Rev. E
10
ENGLISH
ACCESSORIES
VANITY FLAP INSTALLATION
1. Lift upper flap of J3 Back Cover (Fig. 17)
2. Match hook to loop and attach Vanity Flap to the back of the
J3 Back Cover (Fig. 17). Reposition upper flap of cover to
sandwich the Vanity Flap between the flaps the upper and
lower flaps (Fig. 18).
3. Remove Seat Cushion from wheelchair and sandwich “tail” of
Vanity Flap between wheelchair support surface and Seat
Cushion (Fig 20).
4. Adjust Vanity Flap as necessary by moving the tail in or out
from under the Seat Cushion. If necessary the upper part of
the vanity flap can be moved up or down on the Seat Back
also.
5. Insert Hook & Loop Wrap ties through the appropriate
grommets on the Vanity Flap, then wrap around the wheel-
chair frame and insert the leading end through the slot end of
the Wrap (Fig. 21). Snug up and close outside gaps in Vanity
Flap (Fig. 22).
Figure 17 Figure 18
Figure 19 Figure 20
Figure 21 Figure 22
Figure 23
Finished J3 Vanity Flap Installation
To Next Page
Loading...
Need help?
General
