Jaybird Run - How to Reset Your Earbuds; Prepare for Factory Reset; Initiate the Reset Process; Confirm Reset and Re-Pair

16
HOW TO RESET
1
2
3 4
To reset your buds to
their original factory
settings, put your buds
in pairing mode by
turning the buds off.
Push and hold the multi-
function button on the
right bud for about 6
seconds, until you see
the LED flash green.
Now press the button
twice. Upon successful
factory reset, the LED
will turn orange and your
buds will turn off.
Once your buds have
been reset they will
automatically go into
pairing mode once
powered on. Select
“Forget” or “Remove”
Jaybird Run from your
device’s Bluetooth
menu and pair again.
3 SEC PRESS 6 SEC PRESS DOUBLE PRESS