JFTT/JFB/JFD 5-3
V-tech slideout override
If the RV has an underbelly, locate and remove the access
panel to access the slideout motor (this panel is typically
under the RV on the opposite side of the slideout room).
Use a 3/4 or 5/8 socket (size will vary depending on model)
and ratchet on the hex head located on the end of the drive
shaft. Turn the drive shaft until the slideout is in the position
you desire. Contact your RV dealer for service.
M-Tec slideout override
In the event of a power failure or low battery, the slide-out room may be operated
manually with a 5/8” ratchet wrench (not supplied). The manual crank shaft is
located on the motor-transmission housing. Turn the crank clockwise to move the
room “in”, counter-clockwise to move the room “out”.
To Next Page
Loading...
Need help?
General
