117
When set to :
antifreeze will not enter the water heater or the
fresh water tank. There are no dedicated water
heater bypass valves.
9. Turn the water pump ON with the pump switch on the utility center panel. Antifreeze
will be drawn into the water lines when a xture in the RV is opened.
10. Open the hot water line faucets (kitchen/bath sinks, shower (if so
equipped) until RV antifreeze begins to ow continuously.
11. Close the hot water line faucets and repeat with the cold water line faucets (kitchen/
bath sinks, shower ).
: Flush the toilet several times until you see antifreeze in the bowl.
12. Turn the water pump OFF with the switch on the utility center panel.
13. Colored valves should remain in the positions.
14. Remove hose and container from the City Water Fill inlet. Put the cap back on the City
Water Fill inlet. Leave the valves in position.
15. Pour 1 cup of RV antifreeze into any/all drain P traps (sinks and bathtub).
16. Wipe any RV antifreeze out of the sinks, shower (or tub), toilet, washing machine tub,
and dishwasher tub with a soft, dry cloth.
Contact your dealer if you require further assistance.
1. Pour RV antifreeze into the toilet and down into the black
water tank.
2. Turn the macerator pump ON.
3. Run the pump until antifreeze begins to discharge from the
dump connector attached to the ex hose.
4. Turn the macerator pump OFF.
5. Drain the ex hose by holding it at a sloped angle to drain
excess water and return the hose to the storage location.
Water can accumulate in the exible hose and dump connector of the macera-
tor system. When winterizing the RV, antifreeze must be added to the macera-
tor system.
Use a container (bucket) for
capturing system uid.
To Next Page
Loading...
