SECTION 10
CAMPING & OPERATING
65
6. Gently put your truck into reverse (don’t
give it any fuel/acceleration).
This effectively moves the kingpin off the
locking bar that will allow you to
disengage it.
7. Step on brake and apply parking brake.
8. Disengage the locking bar and unhitch.
9. Drive away.
10. If applicable, raise truck tailgate.
11. Adjust the fifth-wheel height for proper
front to back leveling of the RV.
Leveling the RV
Now that you have parked your RV, you need
to ensure it is level. Leveling is very important.
A level RV is more comfortable for sleeping
and walking. The refrigerator is designed to
operate when level for best performance due
to the absorption system. The water drainage
systems are designed with proper slope and
must be level for proper operation. The
appliances perform best when level.
KEYS
Several keys are provided when you
purchase your RV. Most keys have an
individual key number stamped on the plate.
Record these key numbers and keep the
information in safe place. You can order a key
blank from your RV dealer to have duplicate
keys made. If you lose the keys, contact your
RV dealer or a locksmith for assistance.
Make sure the keys are not inside the RV
before you close and lock the entrance
door.
ENTRANCE DOOR WITH SCREEN DOOR
The entrance door is located on the curbside
of the RV. Always hold onto the entrance door
when opening or closing it as damage caused
because you failed to do so is not
warrantable.
BE SAFE, LOOK BEFORE ENTERING OR
EXITING YOUR RV!
HIDE-A-BED (IF SO EQUIPPED)
The hide-a-bed sofa functions much the same
as a regular residential hide-a-bed sofa. To
make the hide-a-bed sofa into a bed, remove
the seat cushions and pull the strap located at
the front of the sofa seat bottom out towards
you firmly and gently.
To convert the hide-a-bed back into the
upright sofa position, reverse the process
(make sure to pull the seat belts out into their
usable positions). Be sure to hold the sofa
strap firmly to ensure the hide-a-bed sofa
does not suddenly drop shut. Refer to the
furniture manufacturer’s care instructions for
this product.
Air mattress (if so equipped)
To make the hide-a-bed sofa into a bed,
remove the seat cushions and pull the sofa
back towards you firmly and gently. Activate
(or deflate) the air mattress using the supplied
furniture manufacturer’s instructions. To
convert the hide-a-bed back into the upright
sofa position, reverse the process .
J-STEEL SOFA (IF SO EQUIPPED)
The J-steel sofa functions much the same as
a residential futon. To make the J-steel sofa
in to a bed, lift up on the bottom seat cushion
and pull it towards you. The sofa back will
drop down to provide a sleeping surface.
For additional comfort and to reduce fabric
damage, you may want to place a cover or air
mattress (customer supplied) over the J-steel
sofa when it is in the sleeping position.
FREE-STANDING TABLE & CHAIRS
(I
F SO EQUIPPED)
The free-standing dinette table can be
positioned to seat up to four people. To
prevent damage, the standard free-standing
Make sure the entrance door is completely
closed and locked when traveling. Locking
the door helps prevent it from opening
unintentionally.
To Next Page
Loading...
