EasyManua.ls Logo

Jayco Embark 2022 - Draining the Fresh Water System

Jayco Embark 2022
165 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
98

rication system manufacturer has supplied a (reusable) plastic bypass hose with ttings on
either end that is designed to replace the water lter cartridge when the motor home is being
winterized or sanitized. Store the hose when it is not in use.
Do not allow water to freeze in the lter.
Remove the cartridge before using antifreeze to winterize or chlorine solution to
sanitize the system.
Flush thoroughly before it is put back into service after winterizing or sanitizing
or if the system has not been used for some time.
For best results replace the lter every 6 months or as needed.

1. Turn o water supply to the lter. Turn the black valve (next to the cartridge lter)
OFF. Water pump should be OFF.
2. Place a cloth under the lter housing to catch any spillage.
3. Relieve pressure on the line (by depressing the drinking water faucet or the paddle on
the refrigerator door) before removing the lter.
4. Unscrew the two ttings from each end of the old
lter or the bypass hose.
5. Remove bypass hose or lter cartridge (dispose of
lter properly).
6. Install new lter screwing it on the two ttings in the
utility center.
7. Turn on the water supply black valve and the water
pump to check for leaks.
8. Make sure if you are using the pump, the Water
Pump Backow Valve is turned ON.

Refer to the water purication manufacturers informa-
tion in the Owners Warranty Packet.

To drain the fresh water holding tank and supply
lines:
1. Make sure the “city water / fresh tank ll valve”
is in the City Fill position.
2. Make sure the “winterize intake valves” are set
to NORMAL
3. Make sure your “water heater bypass” valve is
set to NORMAL.
4. Open the “fresh tank drain”.
5. Open the “low point drains”.
6. Turn on the outside shower faucet.
7. Turn ON the Water Pump Backow Valve if using the water pump. It should be OFF
when using pressurized City Water.
8. Turn ON the water pump and allow it to run as needed.
9. Open all kitchen and bath faucets.
10. Operate the toilet ush lever until water stops owing.
When you are nished draining the fresh water system, reverse steps 4-9 and dump the grey
and black water holding tanks.



Table of Contents

Related product manuals