130
The antenna comes with an emergency power o feature. To activate it, press and hold
“POWER” and then press “SELECT” while still holding “POWER”. The antenna will stop
and turn o. If the emergency power o feature is used, the antenna may not be in a safe
position for travel. Do not move the vehicle until the unit is stowed.
Your recreation vehicle is equipped with an exterior
automatic aiming high denition TV
antenna. This antenna automatically rotates 360°
and is capable of receiving any Over-The-Air (OTA)
high denition television signals being broadcast in
your receiving area (UHF & VHF). The antenna is
controlled through the use of a control plate located
inside the RV above the entrance door.
Refer to the HDTV manufacturer’s manual for detailed operating and safety information.
1. Power on the antenna by pressing the button ).
2. Press the button to initiate a search. Within 2-3 minutes, the antenna will
point where maximum reception is found ().
3. Program the TV Channels:
• Go to Channel Setup on your TV menu.
• Select the Over-The-Air (OTA) antenna.
• Do not select Cable.
• Select Channel Search or . This will program the
stations in your area into the TV. Do this whenever the antenna is
re-positioned.
The antenna is a xed height (7” tall and 15.5” in diameter) and
cannot be lowered or raised. Trees and foliage will interfere with receiving
a strong HDTV signal.
A channel scan must be run to search for and tune in local TV
channels. This feature is built into each TV and is not the same as press-
ing the channel up/down button on the TV remote control. Your TV manual
will explain how to perform a channel scan.
To Next Page
Loading...
