132
If the readout displays “HS” (in manual mode), the antenna has reached the operational limit
and needs to rotate the other direction.
Pressing the Search and Counter Clockwise Rotate button at the same time will reset the
system. Performing a reset can also clear error messages. The following is a list of possible
Error Codes (and resolutions) that can appear on the 2-digit readout during use.
Short in coax between control panel and antenna
Check all cables and connections then perform RESET function on
control panel or disconnect 12 volts.
No antenna detected
Check all cables and connections to antenna.
Motor movement error
Antenna may still function. If problem persists, contact Winegard
Technical Service.
Tuner error. Controls and antenna will still function.
Perform RESET function on control panel. If problem persists, contact
Winegard Technical Service.
Factory Mode
Perform RESET to exit Factory Mode and return to normal operation. If
the above steps do not resolve the issue or another persists, please contact Winegard Techni-
cal Service at 1-800-788-4417 or email help@winegard.com.
Refer to the Winegard owner manual information found in your warranty packet for detailed
instructions on operation and troubleshooting for your automatic antenna and satellite sys-
tem.
Your recreation vehicle is equipped with an exterior high denition TV anten-
na. This antenna manually rotates 360° and is capable of receiving any Over-The-Air (OTA)
high denition television signals being broadcast in your receiving area. The enclosure base
for the antenna (inside the RV on the ceiling) will have a knob that can rotate a full 360° to
adjust for the best signal coming to the antenna.
The antenna base (on the ceiling inside the RV) has a large knob that must be pushed up-
ward to unlock the antenna. The knob can then be rotated 360° and when released locks the
antenna in place.
To scan for local TV stations it is recommended to turn the antenna fully counter-clockwise
until it hits the hard stop (Travel Position). The antenna will be pointing toward the rear of
the RV.
This antenna has a travel position when you are ready to move your RV. Rotate the handle
counter-clockwise (indicated by the arrow on the ceiling plate) until the antenna hits a hard
stop and will not rotate further. Turn o the antenna power supply.
A channel scan must be run to search for and tune in local TV
channels. This feature is built into each TV and is not the same as press-
ing the channel up/down button on the TV remote control. Your TV manual
will explain how to perform a channel scan. (You may have to manually ro-
tate the antenna if no channels are found and do a second channel scan).
To Next Page
Loading...
